A slightly tilted single flower vase based on a 3d scan. The highly complex stump form of the species “Carpinus Betulus” made this tree the perfect selection for this design. The base is slightly enlarged to prevent the Vase from easily tipping over.

Scaling: You can scale this design up and down quite freely.

Size: 129 x 132 x 205 mm

Print settings Required build volume: 140 x 140 x 210 mm Material usage: 130 g

Material: PLA Print direction: stls are rotated correctly, check images Support: none Nozzle size: 0,4 mm Line width: 0,4 mm Layer height 0,2 mm Outer walls: 3 Infill: 15% Build plate adhesion type: none

Watertight printing: If you have a well set up machine it comes automatically - Otherwise here are some tips: Increase your wall count (at least 3), level your bed nicely, decrease print speed, increase layer height (at least 0.2mm), increase print temperature, check your seam quality, calibrate your e-steps and fine tune your retraction settings to make sure no holes appear after a layer change.