Step into the otherworldly with this Stranger Things-inspired shadow box. Inside, a detailed Upside Down scene materializes. Wisps of fog swirl around gnarled trees while a miniature Demogorgon lurks ominously in the darkness. This shadow box encapsulates the show's enigmatic essence, delivering a spine-tingling reminder of the supernatural journey that's captivated viewers. A perfect homage to Stranger Things, this piece beckons you to explore the mysteries that lie just beyond the surface of reality.

This is the first shadow box that uses two-tone plates. Both halves of the plates are held together by tiny clips that are fitted onto the plate. I've added small recesses to indicate where the clips should go. You'll need to print 8 clips, I recommend to print them in the same color as one of the plate halves.

I've used the following colors:

• Plate 1: Eryone PLA Black
• Plate 2 up: Fillamentum PLA Extrafill Pearl -Ruby Red
• Plate 2 down: Fillamentum PLA Extrafill Wizard's Voodoo
• Plate 3 up: PolyMaker PolyTerra Lava Red
• Plate 3 down: Prusament PLA Blend Royal Blue
• Plate 4 up: Fillamentum PLA Extrafill Orange Orange
• Plate 4 down: Tinmorry PLA Sky Blue
• Plate 5 up: Fillamentum PLA Extrafill Melon Yellow
• Plate 5 down: Fillamentum PLA Extrafill Mint
• Plate 6: Tinmorry PLA Glow In The Dark
• Logo: Eryone PLA Black swapped to PolyMaker PolyTerra Lava Red at 8mm (start of layer #40)

The colors are just guidelines, you can get creative with the color scheme for a personal touch.

It consists of 6 numbered plates, 4 of them are assembled using the 2 halves.

I've also added a logo that you can attach to the shadow box.

You can find the box to display this set here

Print settings

Plates & Clips

• No supports
• 100% infill
• Arachne wall generator recommended
• For smooth top finish you could use ironing or print, on smooth buildplate, face down. (not for multicolor).

Logo

• Supports
• 100% infill
• Arachne wall generator recommended

ALL The Crafty Maker designs are protected by Copyright Law. By downloading, YOU HAVE NO RIGHT to sell any digital files or reproductions from those files. If you want a commercial license to LEGALLY SELL 3D prints, you'll need a The Crafty Companion subscription.