By confirming your subscription, you allow Thangs to charge your card for this payment and future payments in accordance with their terms. You can always cancel your subscription.
580Ā downloadsĀ Ā·Ā 6 months agoĀ Ā·Ā **Print-in-place articulated Tiny Owl!**
My smallest design up today š
Keychain version included!
Print-in-place articulated Tiny Owl!
My smallest design up today š
Keychain version included!
Considerations:
It's small and articulated. That means that good bed adhesion is required. For tricky filaments that usually have worse adhesion I recommend using some kind of glue (my personal favourite is 3DLac spray).
Because of its size, I recommend printing them at 0.16 mm layer height. 0.2 mm should work as well.
It has a small built-in brim for the wings. Easy to remove after printing.
It has a couple of support dots in the armpits to help stabilize the wings during printing. It may feel a bit hard to open the wings on the first try, but should be loose after that.
