Qidi Q1 Pro Heater Safety Grille!

Shocking Unprotected?

The new Qidi Tech Q1 Pro 3d printer just launched, and some folks feel the chamber heater is unsafe. The unit has a 110V(or 240v in other markets) chamber heater with mains voltage running through the fins when activated. This could pose a serious shocking hazard if improperly handled. To help mitigate this, I designed up an add-on grate to go in front of the factory grille and provide further protection!

See further discussion & installation of this part here: https://youtu.be/LrkY8-IIHYQ?si=vEiWS41CtoontmyO

NOTE: This is designed to attach to the front an active chamber heater, as such material choice is CRITICAL. USE AT YOUR OWN RISK! Improper material choice could result in fire or molten plastic. Flame retardant filaments are likeliest to be safe but research what is available to you. I take on NO responsibility or liability for damage cause by the use of this part.

Parts Needed (Affiliate Links):

• Qidi Q1 Pro
• Polymaker Flame Retardant Filament

Files Included:

• Q1 Pro Hex Grille STEP File
• Q1 Pro Hex Grille STL

Recommended Print Settings:

• 3 Perimeters
• 40% Infill
• 6 Top/Bottom Layers
• No Supports Required
• Flame Retardant Filament recommeneded.

Want to Support what I do? Check out my social medias please!

Designs covered by a Creative Commons Non-Commercial Share-Alike License. Commercial resale is never authorized without written permission. Want to become an Authorized Reseller? Become a Patron on the “Merchant” Tier on my Patreon to begin selling today: https://www.Patreon.com/MandicReally