Mercury One.1 BEEFY Tensioner Towers

MORE POWERFUL TOWERS!

These parts are my version of the Idler / Tensioner components on a Mercury One.1 build. Used in the conversion of a Creality Ender 5 Pro / Plus 3D printer into a Core-XY BEAST! Check out the full project (and most of the required files) from the Zero-G Team: https://docs.zerog.one/

This is JUST the Idler / Tensioner Towers and the Tensioner Plates. The rest of the files to build a Zero-G Mercury 1.1 are only available from the official repository.

My design is a bit beefier than the original design and stylized to my tastes. These use the exact same hardware as the original Zero-G files and the same assembly method. The only difference is that the “Tensioner Plates” are only designed to be used if you Tap into the end of the Frame Extrusion with a M5 Tap.

NOTE: These parts were designed with a .2mm Layer Height throughout. The rest of the Mercury One files from Zero-G are intended for .25mm base Layer & .2mm Layer Height there-after.

Parts Needed (Affiliate Links):

• M5 Tap
• M5 Roll-In Nuts
• Fabreeko Mercury One.1 Kit
• Polymaker Filament

Files Included:

• Mercury One.1 Idler / Tensioner Tower STEP
• Tensioner Tower Left STL
• Tensioner Tower Right STL
• Tensioner Plate (Print 2) STL

Recommended Print Settings:

• .2 Layer Height On All Layers
• 4+ Perimeters
• 40% Infill
• No Supports Required
• ASA/ABS Filament recommeneded.

Want to Support what I do? Check out my social medias please!

Designs covered by a Creative Commons Non-Commercial Share-Alike License. Commercial resale is never authorized without written permission. Want to become an Authorized Reseller? Become a Patron on the “Merchant” Tier on my Patreon to begin selling today: https://www.Patreon.com/MandicReally