3D model designed to mount a screen lightbar on any 3D printer with V/T-slot aluminum extrusion, specially modelled for 2020 aluminum extrusions. Created to fit Quntis Monitor Light Bars.

To set up the model, you will require four M4x16 screws, two M4 T-nuts, two M4 nuts, and a Quntis Monitor Light Bar. The model's print settings are customizable to your printer's specifications. It was initially printed on a Tevo Tarantula printer using the Ultimaker Cura Slicer. The model is built for three wall perimeters at a resolution of .2mm, with an infill between 15-20% and does not require additional supports. The filament of choice was the OVERTURE PLA Filament 1.75mm, known for its high quality.

A vital printing note is that the arm mount should be printed upright to avoid using extra supports.

Parts Required:

• 4 x M4x16
• 2 x M4 T-nuts
• 2 x M4 nuts
• Quntis Monitor Light Bar:https://amzn.to/4cUAPaR

Print Settings

• Printer: Tevo Tarantula
• Slicer: Ultimaker Cura Slicer
• Wall Perimeters: 3
• Resolution: .2mm
• Infill: 15-20%
• Supports Needed?: No
• Filament Used: OVERTURE PLA Filament 1.75mm: https://amzn.to/3WiE0DK

Notes:

• Arm mount: Printed upright, to not use supports.