LED STAFF - Main Electronics Enclosure Electronics Cradle

This is the piece that all the electronics will be mounted to. It has a hole in the middle that will slide over the copper pipe of the staff and it can be secured by two set screws.

Orientation: print with the flattest side on the build plate Supports: will need a lot of support material because of the print orientation. is best to try and make the cylindrical part as true to round as possible. Also if possible, remove all supports in the internal routing holes (the ones that come off the flat side facing the build plate) that will be used for zip ties. Layer Height: Ideally should be printed at 0.2mm Layer height or even 0.15mm