tracking pixel
Evan P

Bangarang 3 Inch VTX Pigtail Mount & Rx Tray

by

Darkstar77

Follow
Follow
Remix Model
Like
Bangarang 3 Inch VTX Pigtail Mount & Rx Tray 3d model
2D
3D
Makes
Be the first to upload a make
This model is restricted by licensing terms. 
0 Likes8 DownloadsFebruary 10, 2022
This model is restricted by licensing terms. 


These parts are designed to fit over the rear stand offs on the standard Bangarang 3" chassis; may fit the 4" and 5" models, but will not fit the XL 5" and 6" models.

First part is a stand alone VTX pigtail mount with a channel for the battery lead that includes zip tie slots for a small zip tie to hold the power lead in place. This is if you don't need the Rx tray.

The second 2 parts are to be used together. The upper VTX pigtail mount and power lead holder, and the lower Rx tray. The Rx tray should hold up to a XM+ (it will hang a little off towards the stack), but was designed with the R-XSR (no header block), the Radiomaster R81, or similar dual antenna Rx's in mind. There is of course slots for a small zip tie to secure the Rx. The antenna routing holes should accept antenna tube with an OD of around 3.3mm~3.5mm; you may need to add a drop of glue to secure them. The 3.4mm stuff I have friction fits. Alternately you can just run the antenna wires through the holes, and use zip ties and shrink wrap off the arms to mount the antennas. Angle of the holes is 50 degrees, which is slightly tighter than the arms, but should give you good clearance and nearly 90 degree separation of the antennas for best reception.

Print in PLA, PETG, or TPU. The VTX pigtail holders will print without supports; arrange them upside down on the build plate for best results. The Rx tray needs to be printed with supports touching the build plate.

Licensed under Creative Commons, Attribution, Non Commercial, version 4. https://creativecommons.org/licenses/by-nc/4.0/legalcode.txt

00

0 Likes8 DownloadsFebruary 10, 2022




This model is restricted by licensing terms. 
0 Likes8 DownloadsFebruary 10, 2022
This model is restricted by licensing terms.