Logitech extreme 3D pro stick extension

Mount for Logitech 3D pro Joystick. Adds Length to provide higher sensitivity via extra range of movement.

This model is joined using M4 20mm Screws M4 X D6.0 X L5.0 Brass inserts

Please note that the wires housed within the joystick will need to be lengthened. I achieved this by cutting and soldering extra lengths onto the existing wires; although clips could be used.

I printed with PETG at 35% infill but likely PLA is fine .

It is advised to print on its side so that the layer seams run top to bottom. This will provide strength where the joystick clips on to the mount.