Mount for Logitech 3D pro Joystick. Adds Length to provide higher sensitivity via extra range of movement.
This model is joined using M4 20mm Screws M4 X D6.0 X L5.0 Brass inserts
Please note that the wires housed within the joystick will need to be lengthened. I achieved this by cutting and soldering extra lengths onto the existing wires; although clips could be used.
I printed with PETG at 35% infill but likely PLA is fine .
It is advised to print on its side so that the layer seams run top to bottom. This will provide strength where the joystick clips on to the mount.
1 Likes24 DownloadsMay 17, 2022
1 Likes24 DownloadsMay 17, 2022