
Loading preview...
133 Likes3443 DownloadsAugust 10, 2021
This model is restricted by licensing terms.
View license.
Community Uploads
No photos added yet, be the first to upload a photo!This model is restricted by licensing terms.
View license.
133 Likes3443 DownloadsAugust 10, 2021
Community Uploads
No photos added yet, be the first to upload a photo!This is a test print for the collapsing swords and Light Sabers. If you can print thing without the rings sticking together then you should be able to successfully print the full sword.
The test print is a total of 24mm high so I change retraction settings every 8mm. Then I compare the changes until I achieve the best result.
Each printer is going to be different but in my case I used a negative “extra restart” distance to reduce the size of the layer seam. Retraction distance/speed, wipe, coast, temperature, speed may also have an effect.
Category | Hobbies & Games |
133 Likes3443 DownloadsAugust 10, 2021
This model is restricted by licensing terms.
View license.
Community Uploads
No photos added yet, be the first to upload a photo!This model is restricted by licensing terms.
View license.
133 Likes3443 DownloadsAugust 10, 2021