This is a illuminated version of the Galaxy Edge Control Panel #1 I released previously. Like the previous one, the stl’s for this one are also split to be printed in multi-color without supports. The lenses are printed separately and are glued in, I printed them in semi-transparent PETG and turn ironing on. For the white lights, I used white filament and the clear led’s and the thicker lenes named “THK” so they weren’t so bright.

Soldering is not required as I utilized 8mm prewired 24v LEDs and a 2x12 screw terminal power distribution board. You only need to cut and strip the wires to length and terminate them into the board. Put the LED’s in the hole from the back side, aligning the flat on the LED. Then rotate the LED 180 degrees, to lock them in place. I also used a prewired jack to power the board. You will need 2mm x 6mm screws to secure the board. I purchased a 24V 3w Power Supply to power mine.

Note: I had to start suppling the LED's because the amazon seller quit offering them...

Printed on a Prusa XL(aff.) with Polymaker Metallic Pro PLA