Magic Planetary Egg Container
This egg shaped container prints-in-place and uses a planetary gear stage on the bottom which allows it to open 4 times faster than its turned.
This egg is similar to the original Planetary Egg Container, but I wanted to better hide the layer seem so I added details to the outside of the egg to better hide it.
Other Egg Containers: Original Mini Mega
How it works The bottom outside shell is the ring gear, the outer top shell is the carrier, and the inner shell is the sun gear. Rotating the bottom shell while holding the top shell results in the plant gears rotating inner shell at a 4:1 ratio. 36 teeth of the sun, divided by 12 teeth of the planet, plus one.
Print instructions Its roughly 112mm tall, prints in place, designed for a .4mm nozzle, .2mm layer heights, no supports at 100%. There is a 4mm hex hole in the sun gear to free it up the gears if necessary.
Remove the brims There are four built in brims attached to the sun gear that will need to be removed, I did so easily with side cutters
Printed on the Muldex rep-rap IDEX printer with Matterhackers [Quantum dual color filament.
#MakerMadness
Support and Licensing If you would like to help support more free models please consider joining my Thangs Membership To get permission to sell physical copies of my models, consider joining my Patreon