Ichigo's Print-in-Place Collapsing Swordby
Ichigo's Collapsing Sword Print-in-Place Version
This version of the sword prints complete all as one part.
Printing Supports are not required, for best results use a .4mm nozzle. Find detailed instructions on how to print collapsing swords on my website. If this is your first time printing, I would suggest you try the test print first.
The chain is a little hard to print, make sure you use a brim. I also had to print a little slower at a lower layer height to keep it from getting knocked over.
Printed on the Muldex rep-rap IDEX printer.