Hey folks!

You really loved the Grinch Lantern Holder, so I wanted to make another one! And the obvious choice this time was Santa!

The lantern design is different and smaller, and I also improved the way you insert the lights by adding a threaded opening on the bottom. This means you no longer need to tamper with the shade inserts when replacing the light inside. Both lanterns are fully compatible with both hands (Santa / Grinch).

Printing & Assembly:

• Santa’s Hand, the Cuff, the Lantern, the Bottom, and the Snow all require supports (Tree/Organic).
• Place the hand inside the cuff, and then place both into the sleeve. (You can use glue, but it will also hold without it.)
• Use Rub ’n Buff to give the lantern a metallic finish. Insert the shades (optional).
• Place the snow piece on top of the lantern.
• Insert the ring into the hand, wrap it around the top of the lantern, and push it into the designated slot in the hand.
• Insert the light from below.