Jack-O'-Door-Knocker

Hey all!

Hope you like this second Halloween release! This is the Pumpkin Door Knocker! I wanted to make something unique that will stand out and also be super visible, so I think this one can do the trick! (or treat?).

Printing:

• You have to use supports for the head - use either organic/tree supports on buildplate only. Do not go too far with the amount and make sure there is not too much inside so you can easily remove them.
• You may be able to use less supports if you lay it down but print quality will be worse.
• Print the ring also with supports which are required for the upper parts.
• Infill: Use as much infill as possible for the ring so it has some weight - even 100%
• Push the top on the head and carefully put the ring inside the mouth.

3MF files for Bambu AMS included.

Let me know if you would want to see another door knocker for Halloween!