Christmas is coming and the first model is here!

This is Gingerdead! The little guy has two swappable faces and all the parts are printed separately so no AMS required!

Printing:

Body + Head: Use tree/organic supports where needed, make sure your supports are tuned to leave minimal scaring.

Spine: Brim recommended - no supports

All other parts: Do NOT use a brim + You absolutely have to make sure you don't have an elephant foot on those parts or it will make it very difficult to insert. I tested 3 printers for inserting the parts and all fitted well.

Tip: Use a Deburring tool if you do end up with an elephant foot.

All double parts correspond their side on the body/head - meaning the left eyebrow fits the left one on the head.

Hats: Use supports for internal area.

Scale up/down as you please but spine will fuse at smaller sizes.

If you are struggling with the tiny parts let me know in the comments and I'll release another set with higher tolerance for each part!