Members Model Only

Hey All!

So this was requested many times over the last few days - Please read the explanation below:

There are 2 types of keychains as you can see - The side veins had to be thickened in order for them to not snap when printing small. These keychains are currently scaled at 100% - Just like the regular parts you already have.

This means it will fit the current eyeball scaled at the same size (which is a bit big for a keychain!)

So to print at a Keychain Size - Scale it down to about 65%, and with that print all the eyeball parts at the same scale. I would advise printing the "simple" version without the reflection but both will work!

Some notes:

a. Going below 65% the veins may snap (Although mine here in the photos were printed at 60% with success)

b. Silk PLA for the socket/veins will snap more easily than PLA+/non silk - just from my experience.

c. Print the sockets with 3 walls.

d. You can use brim for the tail/sockets for better adhesion.

I will also add single file versions - STL and 3mf files for Bambu later this week!

I also added a version with a hook you can hang on the wall.