My print in place Collapsing Middle-Finger is here! This blew up on Tik-Tok a few days ago and since then some clones started showing up so I hope you will pick mine over the clones :)

V3 Update:

This version has 1 change over V2 - Sometimes the tip can fall inside the hand - if it spins inside it can jump up with the finger being on the wrong side 😅 So in V3 I enlarged the tip of the finger to be a bit larger then the surrounding wall - This prevents it from falling inside thus resolving this issue that sometimes happens - But it also gives the finger a bit of a bulge - So it's up to you what to use! it's not a big issue but I wanted to provide a version that also solves this.

V2 Update:

Changes can be seen in photos:

Shape of the base of the hand was a bit off and way to big - Fixed the proportions of this

Pushed the outer walls so it should be easier to print at smaller scales - I managed to print it at 60% but not smaller than that - If you can , Kudos to you but it's not designed to be printed so small 😉

added some minor details on multiple areas of the hand - Very visible at full scale, less at smaller scale.

Tips:

Avoid using a brim if you can and just watch the first layers as the bridge above the lower collapsing parts is built - This is the toughest part to print (Use glue stick if you have adhesion problems on that part)

You HAVE to make sure you don't have an elephant foot in the first layers.

If the finger wobbles:

1. Use glue / make sure your adhesion is good
2. lower speed
3. Enable z-hop
4. Check Z height make sure it's not to close to bed

if walls get fused:

1. reduce flow / width of first layers
2. make sure you don't have an elephant foot
3. Randomize your Seam