The ultimate symbol of power and destruction—the Death Star. ☄

This latest neon-style piece captures the cold, mechanical beauty of the Empire’s ultimate weapon. A perfect sphere of destruction, with a super-laser capable of wiping entire planets off the map.

By day, its minimalist, geometric design stands out in sharp contrast. But in the dark? It glows like an ominous Imperial control panel.

🎨 These are the filaments I've used

• Bambu Lab Basic PLA Black
• Bambu Lab Basic PLA Glow

Print and assembly instructions

Geometric Art

• 0.20 layer height
• Wall Generator: Arachne
• Top surface pattern: Monotonic
• Infill: 15%
• Color change at layer 21 (4.20mm)

Frame

• Wall Generator: Arachne (otherwise the chances of the print-in-place latches fusing to the frame are higher)
• Infill: 15%
• To loosen the latches move them up a bit before turning them
• Use the latches to secure the artwork into the frame (TIP: add a strip of tape to the back of the artwork where the latch will hold if the latch is too loose)
• When you use the wall hook, make sure you turn the latch under the hook to the locked position before installing the wall hook. Slide the artwork under the locked latch first, position it into the frame and close all other latches

ALL The Crafty Maker designs are protected by Copyright Law. By downloading, YOU HAVE NO RIGHT to sell any digital files or reproductions from those files. If you want a commercial license to LEGALLY SELL 3D prints, you'll need a The Crafty Companion subscription.