The Perliue Stand has a clean, delicate appearance of two layers balanced precariously on four corners. Complete the display with a beautiful flower, dried plant, feather, incense, etc..

4 versions are included with varying hole widths for your stick and each side is 70mm wide. Hole sizes are 1mm, 2mm, 3mm, and 4mm. The top hole is 10mm in diameter. The hole has a cone at the bottom to help friction fit whatever you stick inside, but depending on the object you might use putty or glue to help with arranging your display.

Printing Guide

This model prints on its side and requires no supports. Depending on your bed adhesion, you may want a decent brim. Your default print settings should work fine! I used 0.16mm layer height, and the pictured model uses the 'Fuzzy Skin' setting with 'point distance' of 0.2mm and 'skin thickness' of 0.2mm (this does slightly decrease the size of the inner hole).

Photographed model was printed using Fillamentum Extrafill PLA Traffic White also available at 3DJake and MatterHackers. Printer was the QIDI Q1-Pro 3D Printer*

These affiliate links give me a commission on sales at no additional cost to you. Thanks for supporting Make Anything!.