Vertical PiTFT50 Screen Mount

Touch Your Screen Vertically

This design is a mounting system for a BigTreeTech PiTFT50 screen and a Raspberry Pi 3/4B to be mounted on an upright 20-series extrusion. Personally I used it on my Ender 5 Plus to Mercury One.1 conversion to mount the TFT & Raspberry Pi that runs Klipper for this machine. I've had NO LUCK turning the KlipperScreen interface 90 degrees (portrait orientation) to match this, I just turn my head to look at it...

See my use of this screen & other mods here: https://youtu.be/kmMW6_7lrlQ?si=Uxvht_KfN_OGLHya

This leaves the USB ports on the Raspberry Pi accessible through the bottom and has a grille opening for a 40mm cooling fan. That is intended to be used with my matching Pi/Pico cooling fan mount found HERE.

No supports are required for the “Main Mount”, but the Lid portion requires supports under the Mounting Screw Tabs. See the provided 3MF file from OrcaSlicer to confirm.

Parts Needed (Affiliate Links):

• BigTreeTech PiTFT50
• BigTreeTech PiTFT50 - Amazon
• M5 Roll-in Nuts
• M3 Heat Press Inserts
• 40x10mm Fan 5V
• Raspberry Pi 4
• Raspberry Pi 3
• Polymaker Filament

Files Included:

• Vertical PiTFT50 Screen Mount STEP
• Vertical PiTFT50 Screen Mount Main STL
• Vertical PiTFT50 Lid STL

Recommended Print Settings:

• .2mm Layer Height ONLY (Bridging requires this, .1 could work as well.)
• 3 Perimeters
• 25% Infill
• Supports Required On Lid Only.
• ASA / ABS Filament recommeneded.

Want to Support what I do? Check out my social medias please!

Designs covered by a Creative Commons Non-Commercial Share-Alike License. Commercial resale is never authorized without written permission. Want to become an Authorized Reseller? Become a Patron on the “Merchant” Tier on my Patreon to begin selling today: https://www.Patreon.com/MandicReally