Pica-Pica... PICO? Idk...
While assembling my Voron V0.1 with a BigTreeTech Pico board I didn't care for any of the existing mounting options I found on to print. So I designed this mount for the BigTreeTech SKR Pico board on my Voron V01. It also integrates Cable management down the center of the electronics compartment that accepts the BOM zip ties.
The design can get a little cramped on the left side of the board with cable management, but this was done so you can still use the GPIO connector cable with the board. It exits out that left side so I needed it as close to the left as I could get it to reach my Pi Zero 2w.
Uses M2 screws to mount the Pico board to the bracket and M3 screws to mount through into the V0's extrusions (with pre-loaded nuts).
I also designed a 40mm Fan mount to cool the BigTreeTech SKR Pico board that you can find here: https://social.thangs.com/m/54669
- Necessary Hardware (Affiliate Links):
- 2x M3 Screws (to Mount the Bracket): https://amzn.to/3JPkTIz
- 2x M2 Screws (to Mount Board)
- BigTreeTech Pico Board: https://amzn.to/3HLswOF
- Raspberry Pi Zero 2W: https://www.raspberrypi.com/products/raspberry-pi-zero-2-w/
- Raspberry Pi 4: https://amzn.to/3pHeyas
- ** PRINT PARAMETERS:**
- Recommend 3 Perimeters
- 10%+ Infill (I use Rectilinear)
- NO Supports Required
Want to Support what I do? Check out my social medias please!
Link Tree: http://www.HotRodHippie.com/links
All of my Designs are covered by a Creative Commons Non-Commercial License. Sale of prints using my designs are the sole right of myself, the designer, and those I license to do so. Please understand every design is hours of work and multiple prototype prints to ensure quality. Unauthorized sales will result in new designs not being made public.
PLEASE Credit any and all Remixes of my designs: MandicReally