Print-in-Place DSLR Lens Cap (43->95mm)
110 downloads · 1 year ago · [Relevant Video](https://www.youtube.com/watch?v=0PZjMB03Ujw)
This easy-to-print lens cap prints wi
This easy-to-print lens cap prints with all parts in place, no supports required. Suggested to print at 0.2mm layer height, 3 shells. After printing the 'spring' portion should snap loose with a bit of wiggling.
Swap filament at .8mm for 2 tone graphics
No supports required
Categories:
30 Likes110 DownloadsAugust 8, 2023
This model is restricted by licensing terms.
View license.