tracking pixel
Devin M

PLEIADES Cupholder Waste Bin

by
Make Anything
Follow
Follow
Remix Model
Make Anything
Make Anything
Image 1 of 7
PLEIADES Cupholder Waste Bin 3d model
2D
3D
Makes
PLEIADES Cupholder Waste Bin 3d model
PLEIADES Cupholder Waste Bin 3d model
PLEIADES Cupholder Waste Bin 3d model
PLEIADES Cupholder Waste Bin 3d model
PLEIADES Cupholder Waste Bin 3d model
PLEIADES Cupholder Waste Bin 3d model
PLEIADES Cupholder Waste Bin - Creality Print and Creality Slicer 4.8.2 - I played around with all the "fill tiny gaps" settings and no matter what, this is what is sliced. Help! - 3d model
This model is restricted by licensing terms. 
25 Likes24 DownloadsFebruary 24, 2024
This model is restricted by licensing terms. 


Bring the PLEIADES design series from you home to your car with this little trashcan suited to fit in criminally undersized cupholders. This three part design utilizes a lightweight spiralized bin along with an outer rim that can hold a plastic liner, and a lid with a print in place hinge that keeps your trash out of sight, out of mind.


My PLEIADES series of prints are designed to be printed in vase/spiral mode in your slicer. I suggest printing the 'bin' part with a 0.7-0.8 mm nozzle width (even with a 0.4mm nozzle) and 3-5 bottom layers. No top layers. Make sure your slicer is not set to close small gaps. In BambuStudio I set the 'Slice gap closing radius' to 0 mm

The lid and outer rim can be printed with 3+ shells and 15-25% infill at 0.16-0.2 mm layer height. Depending on the filament and infill% you may want to increase the number of solid top layers on the lid to 6 or 7 for a smooth surface and strength.

Use a small plastic bag for the liner. It may also be used without a liner if you only plan on using it for dry waste.

When attaching the lid to the rim, make sure to line up the connector along the inside edges, which help hold it in place. When separating the parts, it's easiest to pry up from the opposite side (closer to the hinges).


Photographed models were printed on the Bambu Lab X1-Carbon 3D Printer using Bambu Lab PETG-CF filament and Silk Gold PLA outer rim..* *These affiliate links give me a commission on sales at no additional cost to you. Thanks for supporting Make Anything!


25 Likes24 DownloadsFebruary 24, 2024




This model is restricted by licensing terms. 
25 Likes24 DownloadsFebruary 24, 2024
This model is restricted by licensing terms.