This model is restricted by licensing terms.
View license.
I was annoyed by my IKEA EKOLN waste bin moving around when I pressed down the foot pedal, so I made this simple non-slip base to print using TPU filament. The 95A TPU I used did the job, but I'd say the softer the better!
Print with 0 bottom layers and something like 30% gyroid infill to increase grippiness of the bottom surface. Otherwise, standard TPU settings should do the trick. Friction fit.
Photographed model was printed on the QIDI Q1-Pro 3D Printer using BambuLab 95A HF TPU filament.* *These affiliate links give me a commission on sales at no additional cost to you. Thanks for supporting Make Anything!
Categories:
8 Likes15 DownloadsMay 3, 2024
8 Likes15 DownloadsMay 3, 2024
This model is restricted by licensing terms.
View license.