This model is restricted by licensing terms.
View license.
This simple jumpring works better than you might expect for a little piece of plastic! Easy to print in place with no supports required, just separate the small gap after printing. This is a tiny 0.5" diameter variation. I wouldn't dangle my Lambo keys from it, but it is fairly sturdy.
Printing Guidelines
- Print with 4 shells/perimeters to create a solid part
- 0.16mm layer height separates easily after printing
After printing, the gaps should separate fairly easily. You may need to use your clippers to split the ends first, then the remainder of the ring should pull apart.
Categories:
47 Likes116 DownloadsJanuary 9, 2024
147 Likes116 DownloadsJanuary 9, 2024
This model is restricted by licensing terms.
View license.