A super simple way to mount any Raspberry Pi to your 3D printer. Be sure to put some tape over the Vcc pin on the USB cable to stop back-powering the mainboard from your Pi :D

You can print this without support if your printer can do 45 degree overhangs.

To assemble this one you will need atleast 2x M2.5 screws/bolts or some hot glue to attach the Pi, simply slot the mount onto the back of the printer. Cable tie optional.

Print settings: PLA No support Brim 0.22mm layer height 3 layer wall 15% Gyroid infill (probably could go to around 5%)