BuzzBox_Multi

The front panel - you can colour the buttons in with a sharpie

front.stl

Some bits and bobs for the BuzzBox project, check out the full project over on the Core Electronics Maker forum.

speaker_cover

BuzzBox

body.stl

handle.stl

A way to mount larger spools to the side of the Ender 3. You will also need some 2020 extrusion (the same stuff that the crossbar is made of), some T-nuts and some M4x10mm bolts.

I sourced the extrusion and T-nuts from Core Electronics in Australia, links below.

And the M4 bolts from my local hardware store.

https://core-electronics.com.au/slotted-aluminum-extrusion-20mm-x-20mm-610mm-long.html

https://core-electronics.com.au/aluminum-extrusion-slim-t-nut-for-20x20-m4-thread-pack-of-50.html

Print settings:
PLA
No support
Brim
0.25mm layer height
3 layer wall
80% line infill (vary the lines to run parallel with the extrusion)


Ender Large spool mount

printer_mount.stl

A super simple way to mount any Raspberry Pi to your 3D printer. Be sure to put some tape over the Vcc pin on the USB cable to stop back-powering the mainboard from your Pi :D

You can print this without support if your printer can do 45 degree overhangs.

To assemble this one you will need atleast 2x M2.5 screws/bolts or some hot glue to attach the Pi, simply slot the mount onto the back of the printer. Cable tie optional.

Print settings:
PLA
No support
Brim
0.22mm layer height
3 layer wall
15% Gyroid infill (probably could go to around 5%)

Simple 3D printer Pi mount

A super simple way to mount any Raspberry Pi to your 3D printer. Be sure to put some tape over the Vcc pin on the USB cable to stop back-powering the mainboard from your Pi :D

You can print this without support if your printer can do 45 degree overhangs.

To assemble this one you will need atleast 2x M2.5 screws/bolts or some hot glue to attach the Pi, simply slot the mount onto the back of the printer. Cable tie optional.

Activity related to collaborating with others on models

Likes, comments, and activity from your community

A roundup of models that we think you'll like