Decapitated Snowman - V2

Hey all,

I made a lot of updates and additions to the model so releasing it as a standalone additional model, But it includes all the files from the previous model as well

Additions: Body for sideway hands that can hold a head, or a spine + head 2 new hands for the above purpose A short spine that can fit the inside of the Snowman A Holly Hat Dead eyes Fixed original body with improved holes for the hands Pre-colored 3mf files included for relevant parts

Assembly:

• The sideways hands fit the sideway body and visa versa (note the file names)
• You can play around with the looks by mirroring the hands to have 2 holding heads or 2 holding spines etc.
• Snowman will flip to the spine-hand side so you must balance it by either printing a head on the other side or you can put some weights inside the snowman.
• Do not push the "hands-up" to much inside

Printing:

• Hands require supports (tree/organic).
• Heads as well, see tips from previous model regarding the connector head.
• Hats require supports from below.
• Use a brim for the spine.
• You might need some glue to connect some of the parts (eyes, nose, buttons)
• Resize 1%-3% if parts are to tight to fit or too lose