Pig fully articulated
Here is Minecraft Pig fully articulated fan art this Design is pre-painted in bambu studio and Print in Place so no extra parts and painting to worry about, Simply load up the file select your colours and print away. The design can print with out supports but I recommend using them to make the design look better, And once you've printed off the pig you will have to release the legs, They are tight because of the latch to make them easier to print, all you have to do, to release the legs, is put a piece of paper towel in-between some pliers and use the pliers to gently rotate the legs down into position, you can do this with your fingers but I wouldn't recommend as the legs are quite hard to grip onto. But don't worry about the joints, there very strong and I've been extremely ruff with them and have failed to break the joints. check picture for reference. Print settings, Nozzle size 0.4mm, layer Height 0.2mm, Supports needed, Support type normal, Support placement Touching build plate, Support over hang angle 50%, Print speed 50ms, Infill pattern grid, Infill density 15%,