Here is Penguin traps game, super fun for everyone, an absolute must have for game night. This model requires tight pieces with good tolerances, To check if you printed the hex pieces correctly, lay the base down flat upside down and put all the hex pieces inside, check third photo for reference. If you can lift the base up and shake it and no pieces move their too tight if some of the pieces fall out then there too loose. To fix too tight use a knife or blade to shave off the sharp edges on the hex pieces where the first layer connected to the print bed. If their too loose, lay all the pieces in the base again and apply a small amount of glue stick to any of the hex pieces that fall out. Apply the glue to the edges of the hex pieces, then lay them in the base, in position to dry. Any glue stick will work, clear, blue or purple. No supports needed. Printed with a 0.4mm nozzle at 50ms for the penguin player print at 35ms.