Here is Missile toad toy, This super fun play on words toy is locked and loaded to exploded the fun. To assemble print the toad and missile then loosely place a rubber band around the launching arm's on the toads back, Slide the missile down the launching shoot making sure the rubber band sits in the missiles slot in the bottom of the missile, then hold onto the missile with your thumb, aim and fire. if your playing with this toy make sure to wear eye protection and have adult supervision at all times. Print setting's Temp 210c, Bed Temp 60c, Supports needed, support overhang angle 65%, support type normal, support placement touching build plate, support pattern grid, support density 10%, Nozzle size 0.4mm, layer Height I recommend 0.1mm, but 0.2mm will work, Infill pattern grid, Infill density 20%, Print speed 50ms. If your using FlashPrint rotate the toad on the Y 90 degree's twice then 20 degree's on the X.