Decorative box hinged
Here is Decorative box hinged, Modelled after the fancy box I made this box comes with an included hinge. No supports needed for the box, But supports needed for the lid. I wouldn't recommend sizing the box down anymore as the hinges will be come to brittle. Printed with a 0.4 nozzle at Speed 35ms, I recommend changing your layer height to 0.2mm this will help the over hangs in the hinge. For the supports on the lid I recommend using Cura 5.4 and above as these supports are now much easier to remove. Support over hang angle 50% and the supports I used are Gyroid at 15% support density. The Gyroid supports are more random across the hinge and will help to not stick to the small hinges, There's also a correct angle to insert the lid (see Photos), as there is a stopper which helps the lid from not falling out when in use. I recommend using a little bit of sand paper to clean the hinge around where the supports attached, also check the photo where I show how to clear the inside of the hinge with a small drill bit or dremel piece.
Decorative box hinged
Creator 5 Enclosure Door
Bed Scraper
Pokemon Centre Nintendo switch dock multi-part
Bike Phone Holder Mount
Filament Spool with silica Beads storage
Phone Clamp Car holder V2
Flower's Fidget Spinner Pack 001
Flower Pack 003
Car Phone Holder MagSafe Swivel mount
Twisted Full Band Bypass Court half Ct circle cut Ring
Piglin fully articulated
Zombified Piglin fully articulated
Drowned fully articulated
Pinball Customizable Desktop Toy
Enderman fully articulated
Lego hand phone holder
Filament spool adapter
Jungle headphone stand
Crystal Sword Collapsible
