Mini Wind Spinner Balloon

This is a mini version of the original Wind Spinner Balloon. I wanted a small version of the balloon that I could give away at MRRF and the original version is only good to around 175mm. This one is only 100mm tall and printed in about an hour each on the [Mulcore.

This prints all as one piece without supports. I used helper disc’s(brim), to make sure I had enough bed adhesion. I did not use z-hop but that might help keep the fins stable while printing if you have this issue.

I used these Ball Bearing Swivels(aff) to allow it to spin better.

Printed with Eryone Matte Dual Color PLA(aff). I don’t have a picture because I gave them all away.

FYI… if you print in PLA, keep it out of the sun/heat.

Support and Licensing If you would like to help support more free models, or get permission to sell physical copies of my models, consider joining my Patreon