Mini Planetary Egg Container
This egg shaped container prints-in-place and uses a planetary gear stage on the bottom which allows it to open 4 times faster than its turned.
This a scaled down version of the original Planetary Egg Container, I have increased the clearances before scaling it down so they are the same as the original size.
Its just over mm tall, scaled down .625% of the original. Even though it has the same clearances as the original it’s much harder print. The first layer has to be perfect, no stringing, with perfect layer seams.
How it works The bottom outside shell is the ring gear, the outer top shell is the carrier, and the inner shell is the sun gear. Rotating the bottom shell while holding the top shell results in the plant gears rotating inner shell at a 4:1 ratio. 36 teeth of the sun, divided by 12 teeth of the planet, plus one.
Print instructions Prints in place with no supports. I printed it with a .4mm nozzle at .2mm layer heights but a smaller nozzle would make it easier to print as it would give more walls, smaller seam, and more cooling time. There is a 3mm hex hole in the sun gear to free it up the gears if necessary.
Remove the brims There are four built in brims attached to the sun gear that will need to be removed, I did so easily with side cutters
Printed on the Muldex rep-rap IDEX printer with Sunlu Rainbow PLA
#MakerMadness
Support and Licensing If you would like to help support more free models, or get permission to sell physical copies of my models, consider joining my Patreon___ Support and Licensing If you would like to help support more free models please consider joining my Thangs Membership To get permission to sell physical copies of my models, consider joining my Patreon