A simple design I thought would be a nice little gift to all the Rock-n'-Roll lovers out there 🎸🤘🏻 It has no function other than just Rocking 🤘🏻😜

If you have any ideas about making this something functional then let me know in the comments!

It has 3 seats - Rock hand, You Rock and a clean version.

Assembly is very easy, requires no glue and takes about 30 seconds.

Print all parts without any supports.

Place the seat above the small bumps on the Left and Right Sides and push in.

Print 2 x Sticks and push them between each side front and back.

Scaling up and down should be no problem just take into account the tolerance changes if you do so.

Update:

Added additional seat: You_Rock_Seat_V2_Hand.stl with a fixed hand gesture (see last photos to see difference)

Update:

One of you gave this idea so I made a small addon and just "broke" the handles so they can accommodate a smartphone. It was impossible to make the phone stand vertically as the weight will always flip the chair. Even if I managed to balance it by placing it more in the middle, pushing it will end up flipping the chair so for now this will work only horizontally.

Adding here only the altered sides - They work with all "seats" versions.

Update:

Added additional sides that can hold a smartphone that would also work with the Rock Hand - Previous ones were to close to the hand leaving no room to squeeze in the Phone.