Halloween is almost here and I'm trying to squeeze in a few more models 🙂

This is the Dead Ghost Lamp! It's a supe easy print, all multi-part so no multicolor printer is needed. It works with the Bambu Lab LED Lamp Kit-001, But you can also print a closed base lamp and throw inside any battery powered lamp you want.

The lamp base is very simple as I did not want the base of the ghost to be too thick, So no fancy mechanism - it's simple and quirky but it works. You can print a regular or hollow brain if you want the light to go through it.

Printing:

• The Ghost requires supports, use tree/organic supports.
• Use either Lightning infill or set it to 100% infill - Lighting will use less material and be brighter.
• Set the seam position to the back.
• If you are using Lightning infill consider setting "ensure vertical shell thickness" to disabled.

Assembly:

• Eyes are not symmetrical, each eye has a small hollow cylinder at the bottom, This cylinder should be facing the middle of the ghost / mouth - Push the eyes gently but with some force into the sockets.
• Glue the tongue and blood drip.
• Use double sided tape to glue the Led to the base with the cord facing the hole and push the base inside.
• Place brain in place