Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:4804231.

A 7mm endoscope mount to use the HeroMe BLTouch mounts, as I still use the default cr-10 V2 mount. A few variants, I found the variant (V8) which is set back 4.5mm to look round the ducts works well for me but it depends on what you have fitted on your Hero me. The picture is off a cheap 640x480 7mm endoscope have a better one on order.

Been doing some long ABS prints with 110C bed temp the PETG mount went a bit wobbly :-) so ABS would be advisable if you print higher temps than PLA.