Gridfinity USB & Micro SD Holder

1x1 Gridfinity block for storing up to 10 USB devices as well as 3 Micro SD cards. Simple design set up for fast printing.

Recommended settings are as follows:

Layer Height: .32mm Walls: 3 Infill: 10% - 20% (depending on desire) Supports: No

Drives will sit straight up and down but are intentionally a tiny bit loose - in my experience if they are tight in the socket you end up picking up the whole block instead of the drive you want.

Find all of my Gridfinity models here:

https://thangs.com/search/%22--thingymaker9000gridfinity--%22?scope=all

--thingymaker9000gridfinity--

If you find these or anything else I make useful, you can buy me a beer over here:

https://www.buymeacoffee.com/thingymaker9000

Enjoy!