Update 02/2026: I've had one of these installed in the passenger side extended cab door on my 10th generation F-150 since 09/2024. It has held up flawlessly in the brutal Arizona heat, and the truck is parked outside all year. The other factory end just failed on that door, and I replaced it with this 3D-printed one. It also gave me a chance to evaluate the condition of the one that's been there for over a year, and it's super healthy. If anyone is in a cold climate, comment down below whether you've had success with this model!

Compatible with select Ford trucks and vans 1992-2019.

I used this to repair a cable end on my 2002 Ford F-150 SuperCab (extended cab rear doors, upper latch cable).

Make sure to print it laying down with the snap notches pointed up. Supports are recommended. I used PrusaSlicer with on-bed supports only in PETG to make my repair.

This replaces Dorman 926-111.