This is a full set of extrusion channel covers for the Anycubic Kobra Max (for all upward facing channels). If you decide you want some for side-facing channels, you can always modify a piece by dropping it into Fusion 360 and extruding the end faces to get to the desired length. That's what I did starting with the base 10mm segment from Vesh on Thingiverse: https://www.thingiverse.com/thing:4321670
This set includes one for the channel where the filament holder attaches, with a cutout to accommodate it (see image).
All pieces will fit on the bed if you lay them out diagonally, as shown in the image.
Here is a full list of part lengths, how many you need to print of each, and where they go:
- 439mm x1
- 315mm x1
- 315mm w/ 39.5mm x 4.8mm cutout x1, for filament holder
- 292mm x1
- 270mm x2
- 266mm x4
- 236mm x3
- 175mm x3
- 101mm x4
- 94mm x4
- 89mm x1
- 63mm x1
- 61mm x1
- 48mm x3
- 28mm x4
- 18mm x2
- 11.5mm x2
- 10.5mm x4
Total: 42 pieces
- 439mm x1 - Very top rail
- 315mm x1 - Left-front rail, inner channel
- 315mm w/ 39.5mm x 4.8mm cutout x1, for filament holder - Left-front rail, outer channel
- 292mm x1 - Right Y rail, right channel, from front to mid screw (no front screw in this channel)
- 270mm x2 - Right-front rail, inner and outer channels
- 266mm x4 - Left and right Y rails, from the mid screw to the rear screw, both channels
- 236mm x3 - Left and right Y rails, from the front screw to the mid screw, for all channels except the far right one (see 292mm above)
- 175mm x3 - Front-mid, and mid-mid rails (that go under the Y rails)
- 101mm x4 - Left and right rear rails, after cable holder clips
- 94mm x4 - 2 on Mid rail, left side; 1 on Front rail, left side; 1 on Rear rail, left side
- 89mm x1 - Rear rail, right side
- 63mm x1 - Rear rail, mid-left side (between left Y rail and Y motor)
- 61mm x1 - Rear rail, mid-right side (between Y motor and right Y rail)
- 48mm x3 - Y rails, left and right, from front to front screw (except for right channel on right Y rail)
- 28mm x4 - Left and right rear rails, before cable holder clips
- 18mm x2 - Mid rail, right side, from right Y rail to black tape
- 11.5mm x2 - Top rail, between screws on left and right sides
- 10.5mm x4 - Y rails, between mid screws on left and right sides
Also included is a file containing 1 of each piece.