Upload for Search
Search By Text
Upload for Search
Search By Text
Zack F

Gridfinity Printer-Mounted Baseplates

by

ZackFreedman

Follow
Follow
Remix Model
Like
Gridfinity Printer-Mounted Baseplates by ZackFreedman full viewable 3d model
Loading preview...
394 Likes3045 DownloadsApril 13, 2022

This model is restricted by licensing terms. 

Community Uploads

No photos added yet, be the first to upload a photo!

This model is restricted by licensing terms. 

394 Likes3045 DownloadsApril 13, 2022

Community Uploads

No photos added yet, be the first to upload a photo!

Mount storage right to your printer with the Gridfinity modular workshop storage system - whatever machine you use!

Gridfinity is the ultimate organizer for your whole workshop! Learn more at Find more Gridfinity accessories at https://bit.ly/3E2NxnZ

Parametric source files:

These brackets mount to your 3D printer and allow you to put Gridfinity storage blocks right where you need them! These work especially well for the Gridfinity 3D-printer accessory kit.

If you need more adjacent slots, just print multiple baseplates and butt them up against each other. I STRONGLY recommend magnets or screws so you don't knock stuff into your printer!

Anycubic Vyper/Kobra: Also fits any printer made of extrusion with 6mm slots. Mount to your printer's frame with M5 hammer nuts for 6mm slots and M5x12mm countersunk screws. Remember to measure countersunk screws from the TOP OF THE HEAD!

The sidecar baseplate mounts to the base frame, parallel with the floor, a lot like the included filament holder. The top-mount baseplate mounts on the Z axis crossbeam or base frame. Make sure the gantry, extruder, and plate don't collide with your Gridfinity!

Lulzbot: Fits the upward-facing edges of the top crossbars. This one is a real pain in the butt to install.

Prusa: Slides on over the steel frame, no fasteners required. THE BASEPLATE AND EXTRUDER MUST BE ON OPPOSITE SIDES OF THE FRAME!

Snapmaker: Mount to the optional enclosure with M5 hammer nuts for 6mm slots and M5x12mm countersunk screws. Remember to measure countersunk screws from the TOP OF THE HEAD! I didn't make one for the printer itself, sorry!

Toolchanger: Mount to the top of the printer with three button head M3x5 screws. Don't use longer screws! They won't fit!

Gridfinity Tips!

  • No brims or support required!
  • Use any filament with an 0.6mm or smaller nozzle.
  • Wider bins can curl, so maximize your bed adhesion if you're going big!
  • All storage blocks are compatible with all baseplates!
  • Most storage blocks are stackable!
  • You can add 6x2mm magnets to the corners! They won't magnetize the contents.
  • You can also use M3 screws in the corners.




394 Likes3045 DownloadsApril 13, 2022

This model is restricted by licensing terms. 

Community Uploads

No photos added yet, be the first to upload a photo!

This model is restricted by licensing terms. 

394 Likes3045 DownloadsApril 13, 2022

Community Uploads

No photos added yet, be the first to upload a photo!