3D PRINT SETTINGS⚙️

Layer Height: 0.2mm (recommended)
External Perimeter (Outer Wall): 0.33mm (recommended)
First Layer Extrusion Width (Initial Layer Line Width): 0.35mm (recommended)
Only one wall on first layer: True (recommended)
Scale: 100% (Everything is modeled with tight tolerances and should not need to be resized)

⚠️WARNING⚠️ - This pack requires very good bed adhesion to ensure the best possible results for your finished clicker cap. It is recommended to clean your bed with soap and water before printing or whatever your specific printer manufacturer recommends for a deep bed clean!