MeasureOnce156 followers

BookLitho - Pages

42 downloads · 4 months ago · Pages insert for any of our book lithophanes

Description

Pages insert for any of our book lithophanes

Discussions

Pretty Layered2 months ago

You have a suggestion: what light could I use for this?

MeasureOnce2 months ago

I personally have used these bulbs with a standard C7 cord light, and they are way brighter than just about any other light I've found.

Pretty Layered2 months ago

This all is awesome. I have no luck with this part. About after 75% the layers shift due to unstability. :( not sure if the support tree is working

MeasureOnce2 months ago

You shouldn't need any supports on this part. I hiiiiighly recommend enabling brims though, it sounds like you might not have them enabled and they help immensely with keeping the print stable. If you use Bambu Studio, you can find the settings under "Others" in the "Bed Adhesion" section. Set Brim type to "Outer and inner", "Brim width" to 10mm, and "Brim-object gap" to 0

Pretty Layered2 months ago

Thank you for responding. outstanding support. I printed again and again. Then used a cool plate, very slow 50, and strong support. Tadaa... it worked. I didn't see the brim in the settings. It was more on the end layers shifting. Maybe too wobbly because there's no brim. You are the best. Thank you. I will print again with a brim. "Question" -> the small pages for the same size of book? Couldn't figure it out :)

MeasureOnce2 months ago

Awesome, glad it printed well. The small pages are for the A1 Mini versions of the books. Most of the newer models I post have two versions, one standard size (similar to a hardcover book), and one that's smaller and can be printed on an A1 Mini (similar to a paperback size book).