Chromatic Springo

I modeled this springo after my popular Chromatic Vase. It has the same distinct ridges... but it's a springo!

Two sizes. I got the best results printing with 3 outlines/shells, 0.15mm layer height, and enough solid top & bottom layers to make the spring part solid infill. No supports required.

After printing, carefully separate the coil using a thin spatula, palette knife, butter knife, etc. Work slowly and with caution, especially if you are using sharp tools!

Springos pictured were printed using MatterHackers PRO PLA on an older model of this Geeetech Multicolor Printer