Make Anything12K followers

5x5 Puzzle Cube

412 downloads · 3 years ago · Don't underestimate this 5x5 unit puzzle cube, it is a tricky bugger! Try the [3x3 cube](https://tha

This model is restricted by licensing terms.

View license.

Description

Don't underestimate this 5x5 unit puzzle cube, it is a tricky bugger! Try the 3x3 cube for something easier, or go for the 10x10 S U P E R C U B E for a painfully difficult (read: nearly impossible) challenge!

note: the 'solution.stl' is only meant for viewing digitally/in your slicer. Not designed for printing!

Tags:

Community Makes (1)

I think I've been trolled. All the pieces were printed at once as they were imported. I can see no way to complete this puzzle. The "solution" is of moderate help as it only shows the outside.
I quit. I'm calling this unsolvable.

Community Makes (1)

Discussions

erich.schultz2 years ago

I think I've been trolled. All the pieces were printed at once as they were imported. I can see no way to complete this puzzle. The "solution" is of moderate help as it only shows the outside. I quit. I'm calling this unsolvable.

cbrigham8011 months ago

I'm with you. The "solution" is very unhelpful, as it doesn't show enough of the pieces. I spent 3 hours WITH THE SOLUTION and still couldn't get it. While I believe it may be solvable, I had zero fun attempting it. I wasn't going to waste any more filament to print the solution, and even putting the model in my slicer so I could fully rotate it was still awful...would it have killed the author to have made an actual SOLUTION key showing the interior pieces??

DO NOT WASTE YOUR TIME ON THIS

Make Anything11 months ago

What's the fun in getting the full solution? It's a super difficult puzzle, but that's what it's intended to be. My Tsugite Cubes are more manageable (but still tricky), maybe you'll have fun with those :)

TS_Mind_Swept6 months ago

I started to think i was missing something as well, butt I did end up solving it, so the puzzle is fine

TS_Mind_Swept6 months ago

The solution cube does have some of the interior pieces (for some reason.. makes it print like 💩 so I got them out of there, but they are there on this one), not sure how much of a help they'd be, butt you could try looking at them in a 3d modeling program or slicer

Make Anything6 months ago

The solution cube was meant for viewing digitally only, not to print. Sorry that was unclear!

tribvtes6 months ago

whats the print settings ? 3 walls 15 concentric infill 0.12 layer height no supports precise wall precise z height , what about top pattern , bottom layers top layers. best sprase infill pattern for something like this ? thanks