Design to mount a Voron Afterburner on a CR-10 v3. A small adjustment to the X endstop arm should allow using it on a regular CR-10 or Ender 3. There's two basic sets here, a complete carriage replacement named "CR-10v3 Afterburner *" and one that screws to an original CR-10 plate such as [this one](https://www.amazon.com/B085LK3JDH/). For BL-Touch mounting, it can be left off, use the bracket that comes with the kit or available as [Thing 3940873](https://www.thingiverse.com/thing:3940873), or a printed one. Note that using the printed one makes this thing even more painful to print than it already is. I have not yet printed or tested this, waiting for the CR-10 carriage to arrive from Amazon before I print and test it, but I have mounted an afterburner onto an earlier prototype. There's also a cable management bracket that just uses a couple zip ties for train relief. OpenSCAD file available [here](https://www.thingiverse.com/thing:4924924).