After living with my original design for a while, I saw some flaws in it; mainly that I was hitting keys I didn't mean to using the throttles, and that it was harder to reach than it needed to be. This is the second version, which mounts the gherkin keyboard on a 26 degree angle, while moving it back a little. Clears the SEM and THQ modules in the vertical position, not so sure about the FSM-GA module however; it might clear just fine, it might not. I don't own that module.
Print it with the large face, the face the keyboard mounts to, down and you won't need any supports. 0.2 layers are fine. You could probably get away with 0.3 to speed up the print.
Licensed under Creative Commons, Attribution, Non Commercial, version 4. https://creativecommons.org/licenses/by-nc/4.0/legalcode.txt