Upload for Search
Search By Text
Upload for Search
Search By Text
Evan P

3030 Extrusion Mount For 3 Wago 222-413 Blocks

by

Darkstar77

Follow
Follow
Like
3030 Extrusion Mount For 3 Wago 222-413 Blocks by Darkstar77 full viewable 3d model
Loading preview...
3 Likes10 DownloadsApril 11, 2022

This model is restricted by licensing terms. 

Community Uploads

No photos added yet, be the first to upload a photo!

This model is restricted by licensing terms. 

3 Likes10 DownloadsApril 11, 2022

Community Uploads

No photos added yet, be the first to upload a photo!

I designed this for mains wiring up a 3D printer under the hood. The Voron SW uses 2 power supplys, and needs some wiring to be done. I could have used blades, and made a wire harness, but I wanted something I could easily take apart to service. I could have used wire nuts, but they sort of suck. I settles on Wago 222-413 connector blocks. This part is designed to hold 3 of them for the ground, common, and neutral wires from mains wiring. It is designed with the Voron Swithwire in mind, but it should work on any frame with enough clearance for the Wago connectors and the wires. Wago connectors snap into place, and are held quite firmly. You can remove them, but it take a bit of force. Print in ABS or PETG at 40% infill; PLA will work too, but this is most likely going to be under your heated bed with your electronics, making ABS the correct choice.
CategoryHobbies & Games




3 Likes10 DownloadsApril 11, 2022

This model is restricted by licensing terms. 

Community Uploads

No photos added yet, be the first to upload a photo!

This model is restricted by licensing terms. 

3 Likes10 DownloadsApril 11, 2022

Community Uploads

No photos added yet, be the first to upload a photo!